40 Amp 600 Volt Blocking Diode Stud Diode Wind Turbine Generators & Solar Panel

Description

Free shipping to the lower US 48 states only,
excluding PR, Hawaii, Alaska
40 Amp 600 Volt Blocking Diode
These are a must for solar panels or wind turbines that do not have diodes like DIY solar panels, DC wind turbines, or hydroelectric generators.
A blocking diode is used to restrict electrical flow in one direction, similar to a back-flow prevention device.
Please note that
it is necessary to mount this diode in an aluminum heat sink to keep it cool
, otherwise it will burn out. We do not include the heat sink, however, you may easily make your own using any thin aluminum.
What size diode do I need?
Your diode needs to be somewhat larger than the current that is will be handling. If your solar panel will not exceed 2 1/2 of amps of current, then the 3 amp version is fine. The 10 amp diode is acceptable for panels up to about 9 1/2 amps. Solar panels with more charge current then this would require a larger diode (see our 75 amp diode). This larger diode can be placed in-line with the common positive wire coming from your solar panels to your charge controller to handle multiple panels at one time. Please note: A larger diode may require a heatsink if it will be used for higher power applications (above 15 amps or so.)
Do I need a diode for my wind turbine?
You will only need a blocking diode if your motor has brushes (some electric motors like the Ametek have brushes).  The Missouri Wind and Solar Freedom™ and Freedom II™ PMG, Super Dual PMA, and Victory PMA are brushless and do not require a diode.
If the turbine has brushes then yes, you need a diode.
If it is DC motor, then yes you need a diode.
If it is single phase AC you need a single phase bridge rectifier.
If it is 3 phase AC then you need a 3 phase bridge rectifier (like a car alternator), if it is not already included.
Check with your turbine supplier for more info.
Do I need a diode for use with my solar panel?
Solar panels require a diode to prevent current flow back into the battery when there is little or no light. For solar panels, a 3 amp or 8 amp diode can be used for this purpose. You might also want to install a bypass diode to prevent a shaded panel from drawing down other panels. These same diodes can be used. Place diodes in a ABS project box. If you are using a solid state charge controller, you may not need a blocking diode.
Below is an example of how it's installed.
Product Videos:
Solar Panel broken and Blocking Diodes How To fix repair Missouri Wind and Solar - YouTube
Video will open in a new window
[isdntekvideo]
Missouri Wind and Solar How to build a 200 watt solar panel kit  DIY - YouTube
Video will open in a new window
[isdntekvideo]
Missouri Wind and Solar How to build a 3 phase permanent magnet alternator - YouTube
Video will open in a new window
[isdntekvideo]
CLICK HERE TO SEE OUR FULL LINE OF WIND AND SOLAR PRODUCTS!
We do not mark items as gifts or under report values for customs. For International buyers,
it is strongly recommended to check your own country's tax practices as we do not
pay your taxes, duty or customs fees.
We do not over charge for shipping; it is simply what the shipping calculator comes up with.
Customs fees or taxes are not included in shipping, it is your responsibility to pay them.
UPS orders are signature required at our discretion!! Contact us right away if you need to make other arrangements!
Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better.